DataCard LM200 Uživatelská příručka stáhnout pdf (Strana 28)

18 Using the Printer and Laminator

Loading Bottom-Side Laminate Film

1. Openthelaminatordoorbypullingthetopofthedoortowardyou.

2. Removethebottom‐sidefilmcartridge:

Pressthelaminatorcartridgereleasebuttonandremove

thelaminatorcartridgecarefully.Thematerialmustbe

tightwhenremovingthecartridge.

3. Removetheusedmaterial(ifpresent).

Besuretosavethe

emptysupplyspool.(Donotthrowit

away.)Usetheemptyspoolasthetake‐upspoolinstep 4,

ofthisprocedure.

4. Placethenewrollofmaterialnexttotheemptytake‐upspoolonacleansurface.

5. Removethelabelfromthelaminatematerialanduseitto

securethefreeendofthematerialtotheemptytake‐up

spool,makingsurethattheedgesareeven.

6. Loadthenewrollofmaterialonthecartridge:

a. Putthefullrollofmaterialonthesupplyspind le.

b. Puttheemptytake‐upspoolonthetake‐upspindle.

c. Alignthematerialalongthefourmetalguidesas

shownonthecartridgelabel.

d. Windtwoorthreerotationsoffilmontothetake‐up

spool.Takeupslackbetweenthespoolsbyturning

thesupplyknobcounterclockwise.Ifslackcannotbe

removed,verifythatthesupplyandtak e‐upspools

arefirmlyseatedonthespindles.

7. Replacetheloadedlaminatorcartridgeinthelaminator

untilitclicksintoposition.

8. Closethelaminatordoor.

9. Iftheloadingstatusofthecartridgeischangedwhen

changingthesidetobelaminated,thelaminatordoes

notinitializewhenthelaminatordoorisclosed.Press

the

Operatorbuttontoinitializethelaminator.

Take-up Spool

Supply Roll

Guide Shaft

Metal Guides

OperatorButton

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 137 138

Žádné komentáře

DataCard LM200 Uživatelská příručka Strana 28