DataCard UltraGrafix Select Instalační manuál stáhnout pdf (Strana 133)

Maxsys and MX Series Software Administrator’s Guide 121

Running Mini-Cards

Card Setup changes are necessary to run the ID-K specified mini-card (refer to

Datacard ID-K Key Ring Card Specification 553349-001, rev. 04).

Perform the following steps to run mini-cards.

1. In Card Setup create a new, or open an existing Card Setup.

2. Click on the virtual card. In the Card Properties/Settings tab, select the Stock

Description list and then select the MINI_CARD card stock.

The MINI_CARD card stock defines where the break across the stripe is

located on the card. Based on this information it restricts the encoding and the

jitter checking.

3. Place a Magnetic Stripe Read and/or Verify element on the card (or select an

existing element).

4. In the Magnetic Stripe Properties/Settings tab, select the Track Type list and

then select the ID-K standard (e.g. IATA_ID-K or ABA_ID-K). The definition

for the type of magnetic stripe is located in the magnetic stripe setup

application.

5. Save the Card Setup.

Running Jobs that Alternate Between Mini-Cards and

Standard Cards

The best way to alternate between mini cards and standard cards is to define two

specific card setups, one for the mini-cards (see directions above) and the other

for the standard card. Each card stock is put into different input trays and then a

data field is used to call out the tray from which to pick. The tray selection field

would also be used as the card setup selection criteria field to define which setup

to use (mini or standard).

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 321 322

Žádné komentáře

DataCard UltraGrafix Select Instalační manuál Strana 133