DataCard magna Uživatelská příručka Strana 110

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 180
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 109
7-6 Install the printer
User’s Guide for Magna™ Platinum™ Series Printers
Figure 7-6: Connect the parallel port cable
2 Attach the other end of the cable to the parallel port on the PC (see Figure 7-6).
Press the cable connector all the way onto the port, and then turn the posts to
secure the cable to the PC.
Some parallel communication devices use a cable with a plug that allows
another device to be attached, so that two parallel devices are attached to
one PC parallel port, known as a pass-through or piggy-back plug. The printer
and printer driver cannot communicate reliably through such a plug. Install an
additional parallel port in the PC if needed.
Connect a USB data cable
The USB cable must be a type CM 30V cable, up to a maximum of 6.5 feet or 2
meters long. A longer cable might result in electrical interference.
1 Attach the flat end of the USB cable to the USB port on the PC (see Figure 7-7) or
to a device attached to the PC through a USB port.
If the printer has two USB ports, the upper USB port should be identified with
a smart card label and pink plug. Do not use the upper USB port; use the USB
port toward the center of the panel.
i
i
i
Zobrazit stránku 109
1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 179 180

Komentáře k této Příručce

Žádné komentáře