DataCard LM200 Instalační příručka stáhnout pdf (Strana 68)

60 Installing the Status Monitor

5. ChangetheunitnumberattheprinterLCDpanel.

a. PressMenutoenterthemenus.

b. PressNextseveraltimesuntilSettingisdisplayed.

c. PressEntertoopentheSettingmenu.

d. ThefirstsubmenuisDisplay.PressNexttwice.

e. UnitNo.isdisplayed.PressChange.

f. Pressthedownarrowkey

toscrolltothedesiredunitnumber.

Toselectalowernumber,scrollto10andthenpressthedownarrow

keyagain.Thenumberrollsoverto1.

g. PresstheReturnkeytoassignthenumber.

h. PressExittwicetoleavethemenus.

i. Powerofftheprinter.Wait30seconds

ormore.Poweronthe

printer.

6. OpentheStatusMonitorasanadministrator‐leveluser.

Refertothe“UsingtheStatusMonitor”sectionofthe

User’ sGuide.ClickthePrinterSelecttab.

7. Makesurethattheidentifierfromstep 4isselectedinthe

CurrentPrinterfield.ClickRefreshtoget

thenewunit

numberfromtheprinter.

8. ChangethePrinterNamefieldtocorrespondwiththeunit

number.Forexample,ifyousettheunitnumberto8,

changetheprinternametoPRINTER08.

9. ChangetheDefaultInterfacevalueandnetworksettings,andchangeifneeded.

 IftheprinterissettoUSBandyouplantoinstalltheprinterwithanetworkconnection,

changethevaluetoNetwork.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 93 94

Žádné komentáře

DataCard LM200 Instalační příručka Strana 68