DataCard SP75 Plus Instalační příručka stáhnout pdf (Strana 87)

Page 82

MS-01429 Mag Stripe Data

Data sent to a track does not match the requirements for

that track.

Possible Cause 1: Data sent uses a different encoding format than the one

set for the track.

Solution 1: Determine the magnetic stripe formats for the tracks you use.

Change the encoding format(s) in the application so it is set to the same

format as the track(s), make sure the data characters are allowed for the

track(s), and resend the print job.

Possible Cause 2: Data sent uses an encoding format that is not supported

by the magnetic stripe module.

Solution 2: Determine the magnetic stripe formats for the tracks you use.

Change the encoding format(s) in the application so it is set to the same

format as the track(s), make sure the data characters are allowed for the

track(s), and resend the print job.

The magnetic stripe module and cards must be capable of accepting and

encoding each track of data the application sends.

If you cannot fix the problem, contact your service provider for assistance.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 135 136

Žádné komentáře

DataCard SP75 Plus Instalační příručka Strana 87